AQUOR House Hydrant V2+ - Page 5

Aquor
®
House Hydrant V2+
ASSE 1019A CERTIFIED / meets IAPMO/cUPC
11
www.aquorwatersystems.com
(800) 458-1749
Nibs on hydrant faceplate
To connect: Line up the three helical grooves on
the hose connector with the three nibs on the
hydrant faceplate. Simultaneously push and twist
the connector clockwise in a smooth motion. Make
sure to align the grooves fully and push in before
twisting. Water flow will start instantly when the
connector is engaged.
To disconnect: Push the connector in slightly,
then untwist counter-clockwise. The hydrant will
self-drain any remaining water left in the body.
The water will drain for the few moments, this is
perfectly normal.
Remember to depressurize your hose before
storage. It’s best to disconnect the hydrant when
not in use. For the longest lifespan, store your
Aquor
®
hose connectors out of the elements.
Connect hose to hose
connector before
connecting to hydrant.
Grooves on hose connector
OPERATION
Bayonet locking design keeps
connector secure when engaged
Tip: If you leave the Aquor
®
connector attached to
your garden hose, make sure to depressurize the
hose after use. Temperature changes can cause
water inside to expand, causing excessive pressure
on the connector’s internal check valve (and your
nozzle or accessories) over time.
For installation or other technical questions, please
call our customer service team at 1-800-458-1749.