Assembly Tips
An electric screwdriver is helpful in assembly. However, please set at low
torque and use extreme caution with an electric screwdriver because you
could overtighten the hardware and strip the screws.
Start all bolts by hand before tightening.
Some drawings or images in this manual may not look exactly like your product.
Please read and understand the text before starting each assembly step.
Make sure you understand the following tips before you begin to assemble your
dartboard cabinet.
- Phillips Screwdriver
- Small rubber hammer
- Allen Wrench (Included)
3
Make sure you have all the necessary parts before beginning each assembly step.
Perform the assembly steps exactly as written to avoid errors.
Refer to diagrams to aid in the assembly process.
Keep your original receipt and instruction manuals for the cabinet and electronic
dartboard for warranty purposes.
This assembly requires 2 (two) adults.
1.
2.
3.
4.
5.
Find an open area on the floor to perform the assembly, in close proximity to where
you plan to put the finished product.
Carefully open the box. Do not use a knife as you may scratch the cabinet parts.
Remove the inner box holding the electronic dartboard and put it to the side until
you are ready to install it into the cabinet.
Take the cabinet and hardware parts out of the box and make sure all of the parts
are accounted for.
Begin assembly.
1.
2.
3.
4.
5.
1.
2.
To Next Page
Loading...
