Why is the speed reading unstable on my ARAG 400S BRAVO?
If the speed reading is unstable, it might be because the job start procedure was launched too far from the field to be sprayed. To resolve this, start a new job closer to the field.
What to do if the display does not switch on ARAG Desktop?
If the display does not switch on, there could be a couple of reasons. First, check the power supply connection. Second, ensure the computer is turned on by pressing the ON key.
What to do if one valve does not open on ARAG Desktop?
If one valve isn't opening, the cause might be no power supply to the valve. Check the valve's electrical connection and operation.
Why valve controls take no effect on ARAG 400S BRAVO?
If the valve controls aren't working, it might be because the valves are not connected. Make sure to connect the connectors.
General| Series | BRAVO Series |
|---|---|
| RAM | 16GB DDR4 |
| Storage | 512GB SSD |
| Graphics | Intel UHD Graphics |
| Connectivity | Wi-Fi 6, Bluetooth |
| Ports | USB 3.2, HDMI, DisplayPort, Ethernet |
Menu for configuring advanced settings for the system.
Advanced settings for the sprayer, covering spray spots, boom, flowmeter, and valves.
Settings for GPS guidance, including sections and working parameters.
Details automatic functions like nozzle selection, output adjustment, and section management.
Covers error messages, troubleshooting common issues, and cleaning procedures.
To Next Page
