Why is the displayed tank level not precise on my ARAG Bravo 180S?
If the displayed tank level is not precise on your ARAG Farm Equipment, it could be because the level sensor is not calibrated. Perform the calibration or calibrate the level sensor again. Another cause could be wrong installation of the level sensor, so check the connections to the level sensor.
What to do if valve controls take no effect on ARAG Bravo 180S?
If valve controls take no effect on your ARAG Farm Equipment, the valves may not be connected. Connect the connectors.
General| Brand | ARAG |
|---|---|
| Model | Bravo 180S Series |
| Category | Farm Equipment |
| Language | English |
Emphasizes battery disconnection, proper tools, PPE, and using clean water for tests.
Lists essential safety measures like avoiding water jets and using genuine parts.
Specifies precautions for placing the Bravo 180S computer in the cabin for optimal visibility and reach.
Provides guidelines for securing and routing cables to prevent damage and water infiltration.
Explains how to connect the power connector to the farming machine battery, including fuse requirements.
Instructs on connecting control unit valves, ensuring correct seals and connector placement.
Explains how to connect hydraulic valves, ensuring proper seal insertion and connector fixing.
Details connecting various sensors and functions based on assembly diagrams and markings.
Details how to navigate menus, select data, access submenus, and enter numerical values.
Guides through initial tests, checks, and comprehensive computer configuration.
Ensures correct installation of components and connections before computer programming.
Sets the number of installed section valves in the system.
Defines the nozzle actual spraying range by setting individual boom section widths.
Covers settings for calculating vehicle speed using wheel sensors or GPS.
Sets the type of installed valves and their operation modes (section, regulation, main).
Allows selecting the type of flowmeter installed on the system.
Sets the flowmeter constant, indicating pulses per unit of sprayed fluid.
Indicates the full scale of the pressure sensor or sets it to Disabled.
Selects the sensor type (Flowmeter or Pressure sensor) for rate calculation.
Sets the total number of nozzles on the boom for system pressure calculation.
Selects a tank level reading mode (Manual or Level Sensor).
Allows setting tank volume, reserve, and entering the level sensor calibration procedure.
Covers essential settings for a correct job before starting treatment.
To Next Page
