• Have only qualified persons remove doors, panels, covers, or guards
for servicing and maintenance.
• Reinstall doors, panels, covers, or guards when servicing and
maintenance is finished and before reconnecting input power.
Overuse can cause overheating
• Use machine follow duty cycle. Reduce current or reduce duty cycle
before starting to weld again.
• Allow cooling period.
Do not block or filter airflow to unit.
Safety markings
Equipment with CE-markings meets the basic requirements of the
Low-Voltage and Electromagnetic Compatibility Guideline (e.g. relevant
product standards according to EN 60974).
Safety markings
Equipment with CCC markings meets the requirements of
implementations rules for China compulsory certification （ e.g. relevant
product standards according to GB/T 15579）.
Safety markings
CSA marked equipment meets the requirements of the North American
market safety certification implementation rules (e.g. relevant product
standards according to CAN/CSA-E60974,ANSI/IEC 60974)
To Next Page
Loading...
