arcelik 5060 T User Manual (English)

Questions and Answers:

D
David CruzAug 20, 2025
What to do if the arcelik 5060 T Washer door is jammed?
- L
  Lisa AndersonAug 21, 2025
  If the door of your Arcelik washer is jammed, it could be due to a few reasons. First, the water level might be too high; try running the “Pump” or “Spin” program. Second, the machine might be heating water or in the spinning cycle; wait until the process is over. Finally, the door can only be opened a few minutes after the program stops due to an electrical mechanism; simply wait a few minutes and try again.
D
Devin Harding Jr.Aug 22, 2025
Why is my arcelik 5060 T washing time longer than expected?
- C
  connormcclureAug 22, 2025
  There are several reasons why your Arcelik washer might be taking longer than expected: * Low water pressure: The machine waits until there is enough water to avoid poor washing results. * Low supply voltage: Washing time is extended to compensate. * Low input water temperature: The cycle time increases to heat the water. * Imbalanced laundry: The spin correction system might be activated; redistribute the laundry and re-spin. * Increased rinses: The machine may increase the amount of rinse water or add a rinse cycle for better results.
T
Tamara DiazAug 25, 2025
What to do if arcelik 5060 T did not spin?
- B
  Brandon CarlsonAug 25, 2025
  If your Arcelik washer didn't spin, it could be because the laundry is imbalanced. The automatic spin correction system might have been activated. Try rearranging the laundry and re-spinning it. Also, the machine won't spin if the water hasn't completely drained. Check the filter and the drain hose to ensure they are not blocked.
J
Jennifer MartinezAug 26, 2025
Why does my arcelik 5060 T Washer continuously wash and the time doesn't count down?
- S
  Samantha TaylorAug 27, 2025
  If your Arcelik washer is continuously washing and the remaining time isn't counting down, it could be due to a few reasons. If the countdown is paused while taking in water, the timer will not start until the machine is filled with the correct amount of water. If the countdown is paused at the heating step, time will not count down until the selected temperature is reached. If the countdown is paused at the spinning step, there may be an imbalance of laundry in the machine. The automatic spin correction system might have been activated. Try rearranging the laundry and re-spinning it.
R
Robert SantiagoAug 27, 2025
What to do if arcelik 5060 T is continuously spinning?
- C
  Christopher WalkerAug 27, 2025
  If your Arcelik washer is continuously spinning, it's likely due to an imbalance of laundry in the machine. The automatic spin correction system might have been activated. Redistribute the laundry and try spinning again. This system prevents damage to the machine when the load is uneven.
A
amandahernandezAug 29, 2025
How to fix poor washing performance with gray laundry in arcelik Washer?
- K
  keith67Aug 29, 2025
  If your laundry is turning gray after washing in your Arcelik washer, it could be due to: using too little detergent over a long period, washing at low temperatures for too long, using insufficient detergent for hard water, or using too much detergent. Use the recommended amount of detergent for your water hardness and laundry load, and select the correct temperature. Note that it is difficult to eliminate grayness once it occurs.
M
Margaret CaldwellAug 31, 2025
Why does my arcelik 5060 T leave detergent residue in the dispensing drawer?
- L
  Larry SkinnerAug 31, 2025
  Detergent residue in your Arcelik washer's dispensing drawer can occur if the drawer was wet when you added the detergent, the detergent got damp, the water pressure is low, the detergent in the main wash compartment got wet while taking in the prewash water, or detergent is mixed with a bleaching agent. Dry the drawer before adding detergent, store detergent in a dry place, and ensure softener doesn't mix with detergent.
C
Carol OchoaSep 2, 2025
What causes oily stains on laundry after washing in my arcelik 5060 T?
- J
  Jonathan GriffithSep 2, 2025
  Oily stains on your laundry after washing with your Arcelik washer may be due to oily accumulations on the drum. These can result from continuous washing at low temperatures or short programs. To prevent this, leave the detergent dispenser drawer and the loading door ajar after each wash to avoid a humid environment. Also, run the machine empty at 60°C or 90°C with detergent every 6 months.
M
Mark CooperSep 3, 2025
Why does my arcelik 5060 T Washer smell bad after washing?
- J
  John DunnSep 4, 2025
  A bad odor from your Arcelik washer could be due to oily accumulations on the drum. To resolve this, operate the machine empty at either 60°C or 90°C with detergent every 6 months.
K
Katrina PorterSep 5, 2025
What to do if arcelik 5060 T Washer fills with water when a process is cancelled?
- C
  christopher33Sep 6, 2025
  If your Arcelik washer fills with water when a process is cancelled, it's likely because the inside of the machine is hot. For safety, the machine cycles water in and out a couple of times.