Arctic Aire ADR50B6G User Manual (English)

Questions and Answers:

L
Lynn JohnsonAug 9, 2025
Why is my Arctic Aire Dehumidifier running too much?
- R
  russell40Aug 9, 2025
  If your Arctic Aire Dehumidifier is running excessively, it might be due to a few reasons. The area you're trying to dehumidify might be too large for the unit's capacity. Alternatively, open doors and windows can also cause the dehumidifier to run more than necessary. Make sure that all doors and windows are closed to see if that resolves the issue; if not, your dehumidifier might not be adequate for the space.
L
laurie47Aug 15, 2025
Why is my Arctic Aire ADR50B6G Dehumidifier not drying the air properly?
- A
  Antonio ThorntonAug 15, 2025
  If your Arctic Aire Dehumidifier isn't drying the air effectively, several factors could be at play. It may not have been given enough time to remove the moisture initially; allow at least 24 hours after installation to reach the desired dryness. Airflow restrictions from curtains, blinds, or furniture blocking the unit's front or back can also hinder performance. A dirty air filter, humidity control set too high, open doors and windows, moisture from a clothes dryer, or low room temperature can also affect performance. Ensure proper filter maintenance, set the humidity control lower, close all openings, vent the dryer outside, and maintain room temperatures above 5°C (41°F) for optimal moisture removal.
R
Ryan NelsonAug 21, 2025
What to do if my Arctic Aire Dehumidifier does not start?
- T
  Taylor SotoAug 21, 2025
  If your Arctic Aire Dehumidifier isn't starting, there are several potential causes. First, ensure the dehumidifier is fully plugged into the outlet. Check your house's fuse or circuit breaker and replace the fuse or reset the breaker if needed. The unit automatically shuts off when it reaches its preset level or if the bucket is full; adjust to a lower setting or empty the bucket and replace it correctly. The bucket must be correctly positioned for the unit to operate. Also, there's a protective 3-minute delay to prevent compressor overload, so the unit might not restart immediately after being turned back on.