9
For hygienic reasons the appliance (including exterior
and interior accessories) should be cleaned regularly
at least every two months.
CAUTION! The appliance must not be plugged in
during cleaning to avoid potential electrical shock.
Before cleaning, please switch o the appliance and
remove the plug from the main socket.
EXTERIOR CLEANING
To maintain good appearance of your appliance, you
should clean it regularly.
• Wipe the digital panel and display panel with a
clean, soft cloth.
• Spray water onto the cleaning cloth instead of
spraying directly on the surface of the appliance.
This helps ensure an even distribution of moisture
to the surface.
• Clean the doors, handles and cabinet surfaces
with a mild detergent and then wipe dry with a soft
cloth. Caution!
• DO NOT use sharp objects as they are likely to
scratch the surface.
• DO NOT use thinner, car detergent, Clorox, ethereal
oil, abrasive cleansers or organic solvent such
as Benzene for cleaning. They may damage the
surface of the appliance and may cause re.
INTERIOR CLEANING
You should clean the appliance interior regularly.
It will be easier to clean when food stocks are low.
Wipe the inside of the fridge freezer with a weak
solution of bicarbonate of soda, and then rinse with
warm water using a wrung-out sponge or cloth.
Wipe completely dry before putting the shelves
and baskets back. Thoroughly dry all surfaces and
removable parts.
Although this appliance automatically defrosts, a
layer of frost may occur on the freezer compartment’s
interior walls if the freezer door is opened frequently
or kept open too long. If the frost is too thick, choose
a time when the supply of food is low and proceed as
follows:
1. Remove existing food and accessory baskets,
unplug the appliance from the main power
and leave the doors open. Ventilate the room
thoroughly to accelerate the thawing process.
2. When defrosting is completed, clean your freezer
as described above.
CAUTION! DO NOT use sharp objects to remove frost
from the freezer compartment. Only after the interior
is completely dry should the appliance be switched
back on and plugged back into the main socket.
DOOR SEALS CLEANING
Keep door seals clean. Sticky food and drinks can
cause seals to stick to the cabinet and tear when
you open the door. Wash seal with a mild detergent
and warm water. Rinse and dry it thoroughly after
cleaning.
CAUTION! Only after the door seals are completely dry
should the appliance be powered on.
REPLACING THE LED LIGHT
WARNING! If the LED light is damaged, contact the
customer helpline for assistance. To replace the LED
light, follow the steps below:
1. Unplug your appliance.
2. Remove light cover by pushing up and out.
3. Hold LED cover with one hand and pull it with the
other hand while pressing the connector latch.
4. Replace LED light and snap it into place.
CLEANING AND CARE
To Next Page
Loading...
