Arcus 300 - Basic functions; Powering the Amplifier On and Off

14
Basic functions
1. Switching DPA 300 on and off
The central mains switch is located on the rear of the device above the mains plug. Turn this
switch to ON (symbol I) once all components have been connected.
On the remote control the device is put into standby mode via the button
Fehler!
Verweisquellekonntenichtgefundenwerden.
and on the DPA 300 via the top-left On/Off
button (both switch-on and standby).
There are three operation statuses in total:
1) Switched off – the DPA 300 is not consuming electricity
2) Switched on – the DPA 300 is ready for operation
3) Standby – the DPA 300 is on standby and is consuming very little electricity.
How to switch the device on and off and put it into standy mode:
Switch on: Press Fehler!Verweisquellekonntenichtgefundenwerden.
Standby: Press
Fehler!Verweisquellekonntenichtgefundenwerden.
Switch off: Turn off mains switch on the rear



7