11
Furnace Options
for circulation, disconnect and remove the coil. To seal the
holes, use two 25 mm (1") diameter standard washers per hole,
and use a 19 mm x 25 mm (3/4" x 1") bolt to hold the washers
together.
PAINT
You may touch up the face of the furnace with STOVE
BRIGHT Satin Black 1990 high temperature paint. The correct
paint is available from your dealer. When you paint the face of
the furnace, cover the area surrounding the furnace with
newspaper. Follow the directions outlined on the spray can.
DO NOT attempt to paint while the furnace is still warm. Keep
the spray can away from any source of heat or open flame.
Ensure that there is adequate ventilation in the room, from the
time you start painting until the paint is dry.
To Next Page
Loading...
