To Next PageTo Next Page
Need help?Do you have a question about the Argo AT0623 and is the answer not in the manual?
General| Room Size | Up to 60 m² |
|---|---|
| Power Output | 6 kW |
| Frequency | 50 Hz |
| Dimensions | 740x440x235 mm |
| Weight | 24 kg |
| Heating Element Material | Stainless steel |
| Mounting | Wall-mounted |
Details the electric hydronic block as a heating device converting electrical energy to heat.
Lists the key features and capabilities of the Argo electric boiler control system.
Instructions for unpacking and inspecting the boiler unit for damage or missing parts.
Guidelines for designing the circulating system including primary/secondary piping and flow rates.
Procedures for connecting supply and return piping, including low water cutoff and backflow preventer.
Guidelines for boiler wiring, including material requirements and connection methods.
Best practices for field wiring, including conductor types, strip length, and termination.
Explains the operation of limit controls for safety and system management.
Provides guidelines for installing the thermostat for optimal performance and accuracy.
Details how to connect pump and thermostat wiring to the control board terminals.
Instructions for setting operating modes, temperature scales, and other configuration parameters.
Explains the meaning of various display codes for boiler status and operation.
Lists and describes fault codes, their causes, and required actions for diagnosis.
Steps for the initial startup of the boiler, including power application and bypass modes.
Details operation for controlling two loads, like comfort heating and domestic hot water.
Guide on how to set desired water temperatures for heating and hot water.
Describes the sequence of events when the boiler operates to provide heat.
Explains the dry fire test function, its purpose, and how it operates.
Information on using the LMC feature to temporarily de-activate the boiler for peak demand periods.
How to connect and utilize a flow sensor to prevent operation without water flow.
Details on connecting a low water cutoff sensor for safety and preventing dry operation.
Explains the timers that prevent rapid cycling of heating elements and pumps.
Describes the automatic pump exercising feature to prevent seizing.
Explains that user settings are retained even after power loss.
Lists and explains various fault codes, their indicators, and required actions.
Guide for entering and using the installer test mode for unit verification.
Detailed wiring diagram for a 2-element boiler configuration with breakers.
Detailed wiring diagram for a 4-element boiler configuration with breakers.
Steps for putting the hydronic block into service, including breaker checks and system filling.
Wiring diagram for a single zone system with circulators for two boilers.
Wiring diagram for a two-zone system with circulators for two boilers.
Wiring diagram for a three-zone system using zone control valves for two boilers.
Wiring diagram for a three-zone system using zone control valves.
Wiring diagram for a three-zone system using circulators.
Identifies potential causes and solutions for noisy boiler operation.
Step-by-step guide for safely replacing a heating element.
Table of faults, possible causes, and corrective actions for AT boiler issues.
Explains troubleshooting steps for flow switch alarms and related system issues.
Guide to troubleshooting low water cutoff alarms and water level issues.
Steps to diagnose issues when the control display is dark or unresponsive.
Addresses issues where the boiler operates but does not produce heat.
