Do you have a question about the Argo AT1644 and is the answer not in the manual?
Details the boiler's design, ASME compliance, efficiency, and standard features.
Guidelines for primary/secondary piping, flow rates, and temperature considerations for system design.
Requirements for water connections, low water cutoff, and pipe flow direction for safe installation.
General wiring guidelines, codes, wire types, and installer connection specifics for safe electrical setup.
Instructions for connecting thermostats, pumps, and control board wiring for boiler operation.
Identifies controller buttons, LEDs, and display functions for basic operation and monitoring.
How to configure operating modes, temperature scales, and heating elements for desired comfort.
Explains Load Management, Flow Sensor, and Low Water Cutoff inputs and their safety functions.
Details common fault codes, their causes, and required actions for troubleshooting and maintenance.
Addresses noisy boilers and procedures for changing heating elements for repair.
Table correlating faults with possible causes and corrective actions for effective diagnosis.