Argo Bear - Filling the Water Tank; Cleaning; Maintenance and Storage

11
V 12/15
WARNING!!
DO NOT REMOVE THE WATER VALVE IN THE TANK FROM ITS PLASTIC SUPPORT.
REMOVE THE VALVE FROM ITS HOUSING TOGETHER WITH THE SUPPORT, OR AVOID
REMOVING THE VALVE AND FILL THE TANK USING A JUG.
THE TANK MUST BE FILLED WITH DEMINERALISED WATER FOR OPERATING THE
APPLIANCE IN THE COOLING/HUMIDIFICATION MODES.
Counter-rotate the tank knobs by 90° and remove the tank from its housing; fill it with demineralised water up to the
maximum level mark. Replace the tank into its housing and turn the knobs.
If you wish to keep the water in the tank below room temperature for long (up to 4 hours) in order to maximise cooling during
the warmer months, add one of the two synthetic ice packs supplied to the water in the tank, after leaving the pack to freeze
into a block in the freezer.
The ice will absorb heat from the water. We recommend using ice continuously for optimising the cooling capacity. When ice is
used for the first time, you may detect a smell or the water may change colour: there are no risks for human health.
If the tank is extracted while the appliance is operating, the power supply cuts out and the appliance emits a signal before it
stops functioning. Press the ON/OFF button to restore the appliance's operation.
If the tank lacks water for a few seconds, the cooling function is interrupted and only the ventilation function remains active.
MAINTENANCE AND STORAGE
CAUTION: ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE
OPERATIONS.
IMPORTANT: DO NOT SUBMERGE THE PRODUCT IN WATER
Cleaning the outside surface of the appliance
Use a soft cloth to remove any dust from the product.
Should this not suffice, use a soft cloth dampened with water and neutral detergent at a temperature below 50°C. Leave the
appliance to dry fully before using it again.
Do not use corrosive detergents or solvents such as petrol. Do not wash the appliance with water. Do not use oils, chemical
substances or other items that may damage the surface to clean it.
Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.
Cleaning the dust filter, cooling panel and tank
Clean the dust filter frequently, at least once a month.
Remove the dust filter and extract the cooling panel, as shown in the diagram below.
FILLING THE WATER TANK