49
V 09/22
NOTES FOR HEATING FUNCTION
• When the heating function is started, the indoor unit fan will not work immediately to avoid the introduction of
insufficiently hot air into the environment.
• When the outdoor temperature is very low and the humidity is high, ice may form on the heat exchanger of the outdoor
unit. Then the air conditioner will start defrost function.
• During defrost, the air conditioner will stop heating for about 5-12 minutes.
• Vapor may come out from the outdoor unit during defrost. This is not a malfunction, but a result of fast defrost.
• Heating will resume after defrost is complete.
NOTES FOR TURNING OFF
• When the air conditioner is turned off, the unit may continue to ventilate for a few minutes to help dry the battery of
the indoor unit.
EMERGENCY OPERATION
• If the remote control is faulty, use the emergency button located under the front
panel of the indoor unit (see image).
• If this button is pushed with the unit OFF, the air conditioner will operate in Auto
mode.
• If this button is pushed with the unit ON, the air conditioner will stop running.
AIRFLOW DIRECTION ADJUSTMENT
1. Use the vertical oscillation button on the remote control to set the direction of the
air flow.
2. It is possible to direct the air flow also horizontally; this operation is only possible
manually, by moving the air delivery flaps as desired (see image).
Note: Move the air vents before the unit is in operation, or your finger might be
injured.
Never place your hand into the air inlet or outlet when the air conditioner is in operation.
button
To Next Page
Loading...
Need help?
General
