13V 07/22
cause the risk of re. Do not use a single extension cord to operate
multiple appliances.
• Do not immerse the cord, plug or any other element of the appliance in
water or other liquids.
• Do not touch the plug with wet hands.
• Do not place the carbon ber heater above or near another heat source.
WARNING: AVOID COVERING THE CARBON FIBER HEATER TO
PREVENT IT FROM OVERHEATING.
The symbol below signals the above warning:
• The carbon ber heater may cause the risk of re if, while in operation,
is covered by or comes into contact with inammable material including
curtains, drapery, blankets, etc. KEEP THE CARBON FIBER HEATER
AWAY FROM THESE MATERIALS.
• Do not connect the appliance to the mains power before it has been
properly assembled and positioned.
• Do not run the cord under carpets. Do not cover the cord with blankets,
carpets or similar materials. Place the cord far away from busy areas or
where it cannot be accidentally pulled-out.
• Do not operate the carbon ber heater in close proximity to bathtubs,
showers, washbasins or pools.
• Do use the appliance in the bathroom.
• The heating appliance must not be positioned immediately below a
power outlet.
• Do not operate the appliance outdoors.
• Upon initial start-up, the carbon ber heater may emit a slight, harmless
smell. This smell is a normal effect of the initial heating up of the internal
heating elements, and should not recur later on.
WARNING: DO NOT DEPEND ON THE ON/OFF BUTTON SWITCH
AS THE SOLE MEANS OF DISCONNECTING POWER. WHEN
SERVICING OR MOVING THE CARBON FIBER HEATER, ALWAYS
UNPLUG THE POWER CORD.
• A carbon ber heater has hot and arcing or sparkling parts inside. It
must not be used in potentially dangerous locations such as ammable,
explosive, chemical-laden or wet atmosphere.
• Do not place the carbon ber heater on soft surfaces, like a bed, where
To Next Page
Loading...