ON/OFF BUTTON: Press this button to turn ok/off the fan heater.
ECO BUTTON: press this button to activate/deactivate ECO SMART function.
If the room temperature is below 18°C the fan heater will work in high heating
mode(2000W) when the temperature reach 18°C the fan heater will work in low
heating mode (1000W) when the room temperature is 25°C the fan heater stops
working and enter in stand-by mode. When room temperature decreases of 1°C
the fan heater will star to work again in low heating mode to reach again 25°C.
TIMER BUTTON: in working status you can select the timer off function. The timer
off can be setted (1-2-4-8 hours). If timer function is on the LED of the timer is on,
if no timer is sed the timer LED is off.
TEMPERATURE BUTTON: Select to activate countinuos mode, the fan
heater will work continuously until room temperature is 35°C. Press again this
button to select default temperatures (22°C-26°C-30°C). When the selected room
temperature is reached the fan heater will enter stand-by mode, when roome
temperature decreased of 1°C the fan heater will start to work again.
MODE BUTTON: Press this button to select the 3 different working modes:
SWING BUTTON: Press this button to activate/deactivate the swing function
REMOTE CONTROL
Use Lithium/Manganese button cells, model no. CR2032 -3 V, conforming to Battery Directive no. 2006/66/EC and
modification by Dir.no 2013/56/EU (supplied with the remote control).
HOW TO INSERT / REMOVE THE REMOTE CONTROL BATTERIES (refer to the diagram below)
Open the battery cover at the back of the remote control (press the back and pull the flap). Insert the battery into the slot,
making sure you respect the polarities. Put the cover back onto the remote control.
To Next Page
Loading...
Need help?
General
