Argos Washington - Assembly Steps; Steps 3-5: Panel and Plinth Preparation

Assembly Instructions
7
Step 3
Insert Support pin W into
top 9. Let the flat side of
support pin W face the
same side as the finished
front edge of top 9.
Do not overtighten.
C
Finished
top edge
Step 4
Insert large locking nuts C
into bottom 0.
Make sure the ‘arrow’ on
large locking nuts C
points towards the hole in
the edge of bottom 0.
Step 5
Put drop of glue g into
the 4 holes of plinth !
Insert wood dowel M into
the 4 holes of plinth !.
M
M
M
M
AG
AG
W
M
AG
9
10
11
W
W
C
C
C
C
C
C