Argos Washington - Assembly Steps; Step 2: Right Side Panel Preparation

Assembly Instructions
6
Step 2
a:
b:
c:
a: Press the Nylon plug S
firmly into right side 2.
Screw 8.5 mm locking
screw J into right side 2.
Note: Insert 8.5mm locking
screw J as far as shown.
Do not over tighten.
Press the double nylon plug
P firmly into right side 2.
Screw hinge back Y onto
right side 2.
b: Attach hanger rail
support Q using
screw E onto right side
2.
c: Screw 24mm locking
screw A into right side 2.
Note: Insert 24mm locking
screw A as far as shown.
Do not over tighten.
Finished
front edge
Finished
front edge
Finished
front edge
ID-hole
ID-hole
S
P
J
J
Y
Y
Y
Q
E
A
A
A
S
J
Y
P
Warning: Do not use an electric screwdriver to attach the
hinges as this can weaken the fixing.
2
2
2
A