What to do if my Ariens Snow Blower engine will not start?
If your Ariens Snow Blower engine won't crank or start, try the following: Fill the fuel tank, open the fuel shut-off valve, clean the area around the governor/carburetor, put the key switch into the run position, and check for a bad starter or connections.
How to fix an Ariens Snow Blower that doesn't throw snow?
If your Ariens Snow Blower throws snow poorly or not at all, try these solutions: Replace the shear bolts, move the unit to a warm place to thaw, and with the engine off and auger disengaged, check for and remove any obstructions.
Why does my Ariens Snow Blower engine keep stopping?
If your Ariens Snow Blower engine stops, you can try these steps: Fill the fuel tank, open the fuel shut-off valve, turn off the engine, remove the key, and wait for all moving parts to stop. Check for and remove any obstructions before restarting. Replace the fuel with clean fuel and replace or clean the spark plug.
Why are there small rubber beads collecting in the frame of my Ariens 932048 - ST5520 Snow Blower?
The collection of small rubber beads in the frame of your Ariens Snow Blower is likely due to normal friction disc wear. If you notice chunks or large pieces of rubber, the friction disc should be checked and replaced if necessary.
General| Clearing Width | 20 in |
|---|---|
| Forward Speeds | 6 |
| Reverse Speeds | 2 |
| Product Type | Two-Stage Snow Blower |
| Starting System | Electric start |
| Drive Type | Wheel |
| Engine Brand | Ariens |
| Engine Type | 4-cycle |
| Auger Material | Steel |
| Chute Control | Remote |
| Chute Rotation (degrees) | 200 |
| Tire Size (in) | 13 x 4 |
| Skid Shoes | Yes |
| Headlight | Yes |
| Auger Type | Serrated |
| Tire Type | Snow |
| Clearing Width (in) | 20 in |
To Next Page