Why Ariens Lawn Mower engine does not crank?
If your Ariens Lawn Mower engine doesn't crank, it could be due to several reasons: * The PTO might be engaged. Disengage it. * The parking brake might be disengaged. Engage the parking brake. * The battery cables could be loose or corroded. Clean and tighten them. * The battery might be discharged. Charge the battery. * The starter might be faulty. In this case, consult your Gravely Dealer.
What to do if Ariens GRAVELY Pro-Turn 400 engine cranks but does not start?
If your Ariens Lawn Mower engine cranks but doesn't start, consider these possibilities: * The fuel tank might be empty. Refill it. * The air cleaner could be plugged or dirty. Clean or replace it. Consult the Engine Manual for detailed instructions. * The fuel filter might be dirty. Clean or replace the fuel filter. * There could be a fault with the engine. In this case, refer to the Engine Manual or see your Gravely Dealer.
Why Ariens Lawn Mower unit does not drive?
If your Ariens Lawn Mower doesn't drive, check the following: * Ensure the parking brake is disengaged. * Verify that the transmission bypass levers are closed. * Check the hydraulic oil level and add oil if it's low. * If the issue persists, there may be a problem with the hydraulic drive system. Consult your Gravely dealer.
What to do if Ariens Lawn Mower engine is overheating?
If the water temperature gauge on your Ariens Lawn Mower is reading above normal, indicating the engine is overheating, check these: * Ensure the engine oil level is adequate. Add oil if needed; refer to the Engine Manual. * Verify the coolant level and add coolant if it's low. * Inspect the radiator for any blockages from debris and clean it. * If none of these resolve the issue, the radiator may be faulty. See your Gravely dealer.
Why Ariens Lawn Mower PTO or mower blades do not engage?
If the PTO or mower blades on your Ariens Lawn Mower do not engage or shut off, it might be because the operator presence switch is not depressed. Make sure you are sitting on the seat to depress the switch. Alternatively, there could be a faulty PTO switch. Inspect the electrical system to the clutch for damage or wear, or see your Gravely Dealer.
How to stop Ariens GRAVELY Pro-Turn 400 Lawn Mower engine that keeps running?
If your Ariens Lawn Mower engine continues to run even when the ignition key is in the off position, it could be due to a disconnected ignition ground wire. Connect the ground wire to a clean metal surface. Another possibility is an ignition switch failure, in which case you should replace the ignition switch (see your Gravely Dealer).
General| Brand | Ariens |
|---|---|
| Model | GRAVELY Pro-Turn 400 Series |
| Category | Lawn Mower |
| Language | English |
To Next Page