GB - 7
Tools Required
•1/2" Wrench
• Needle Nose Pliers
Unpack Unit
Remove unit and all other components from
the shipping container. Push unit from
container onto a level surface.
Assemble Handlebars
1. Rotate handlebars into the operating
position and secure with the bolts and
lock nuts.
2. Connect the depth control rod to the
cutting height lever and to the cutting
depth adjuster with two hairpins.
Check Engine Oil
1. Fill engine crankcase with oil. See
engine manual.
Check Engine Fuel
1. Fill fuel tank. DO NOT OVERFILL! See
Check Engine Fuel on page 7.
Check Safety Interlock System
See Operator Presence Control on page 9.
ASSEMBLY
WARNING: AVOID INJURY.
Read and understand the entire
Safety section before
proceeding.
WARNING: Safety interlock
failure and improper operation of
unit can result in death or serious
injury. Check system before each
use to make sure it is functioning
properly.
To Next Page
Loading...
Need help?
General
