Ariens Path-Pro User Manual

EN - 3
Engage auger control bar (# 2) to ensure proper
operation. There should be no excessive tension on
cable. When auger control bar is disengaged, there
should be slight slack in cable and no tension.
See Owner’s Manual if adjustment is necessary.
Add oil. (Models 938031, 032, 033)
a. Open fuel and oil door (# 15) to access oil fill
(# 12).
b. Remove cap and add 16 oz. 5W-30 oil (# 20).
Check oil level on dipstick to ensure proper
operating level. See Owner’s Manual for
instructions.
c. Replace cap and close door.
Add oil. (Models 938030, 034)
a. Remove cap from oil fill (# 11) and add 16 oz.
5W-30 oil (# 20). Check oil level on dipstick to
ensure proper operating level. See Owner’s
Manual for instructions.
b. Replace cap.
5.
6.
18
8
19
Models 938030, 031, 032, 034
6
WARNING: AVOID INJURY. DO NOT
proceed until operation and safety rules
are fully understood.
Read and understand entire Owner’s
Manual before proceeding.
12
20
15
11
20

Ariens Path-Pro Specifications

General

Engine Brand	Ariens AX
Start Type	Recoil
Fuel Type	Gasoline
Type	Single-stage
Clearing Width	21 inches
Drive System	Auger-propelled
Starting System	Recoil