Ariens Sno-Thro 939003-ST520E

Questions and Answers

M
Michael SanchezJul 30, 2025
Why does my Ariens Sno-Thro 939003-ST520E engine stop?
- P
  ppetersenJul 30, 2025
  Your Ariens Snow Blower engine might stop for several reasons: it could be out of fuel, so check and refill the fuel tank. There might be a mechanical jam in the blower rake or impeller; in this case, turn off the engine, remove the key, wait for all moving parts to stop, then check for and remove any obstructions before restarting. A polluted fuel supply or a faulty spark plug can also cause the engine to stop; replace the fuel or clean/replace the spark plug to resolve these issues.
C
Christopher JenningsAug 6, 2025
What to do if my Ariens Sno-Thro 939003-ST520E engine will not crank/start?
- J
  Jessica HernandezAug 6, 2025
  If your Ariens Snow Blower engine won't crank or start, there are several things you can check: * Ensure the fuel tank isn't empty and fill it if needed. * Inspect the area around the governor/carburetor for any dirt or residue buildup and clean it. * Verify that the key switch is in the run position. * If you're using an electric starter, check for a bad starter or faulty connections.
J
Jeffrey SmithAug 14, 2025
Why Ariens Snow Blower unit throws snow poorly or does not throw snow?
- A
  Amanda SmithAug 15, 2025
  If your Ariens snow blower isn't throwing snow well or at all, consider these potential causes: * Broken shear bolts: Replace them. * Improperly adjusted attachment clutch/brake: Adjust it. * Auger is frozen: Move the unit to a warm place to thaw it. * Ice or debris obstructing the auger: With the engine off and auger disengaged, check for and remove any obstructions. * Slipping, worn, or damaged attachment drive belt: Adjust or replace the attachment drive belt.
M
Mr. Shane Porter MDAug 22, 2025
What to do if Ariens Snow Blower does not drive forward?
- T
  Travis HeathAug 22, 2025
  If your Ariens Snow Blower isn't moving forward, it could be due to a traction drive cable that isn't properly adjusted or a traction belt that isn't functioning correctly. You should adjust the traction drive cable or repair/replace the traction drive belt.

Summary

SAFETY

SAFETY ALERTS AND SYMBOLS

Explains symbols and signal words for safety precautions and warnings.

OPERATIONAL SAFETY PRACTICES

Covers safe working precautions, laws, and operator training requirements.

SAFETY DECAL LOCATIONS

Instructs to replace safety decals and refers to figure for locations.

CONTROLS AND FEATURES

Control Levers (Traction & Attachment)

Operation of the left hand traction and right hand attachment clutch levers.

Snow Clean-Out Tool

Highlights the warning about using the tool for chute cleaning, not hands.

OPERATION

Chute Operation & Clearing

Instructions for clearing the discharge chute, adjusting deflector, and chute rotation.

Fueling and Pre-Start Checks

Guide to filling the fuel tank and performing essential pre-start inspections.

Starting and Shutting Off the Engine

Step-by-step procedures for starting and stopping the engine, including emergency stops.

Snow Removal Techniques

Tips for effective snow removal and proper operation during use.

MAINTENANCE

Maintenance Schedule

Engine Oil Checks & Changes

Auger Gearcase & Lubrication

SERVICE AND ADJUSTMENTS

Scraper Blade, Runners & Shear Bolts

Clutch and Brake Adjustments

Drive Belt Replacement

TROUBLESHOOTING

Engine Not Cranking;Starting

Engine Stopping Issues

Drive System Problems

Snow Throwing Performance

Ariens Sno-Thro 939003-ST520E Specifications

General

Engine	Ariens AX 208cc
Starting System	Electric Start
Auger Material	Steel
Clearing Width	20 inches
Intake Height	12 inches
Drive System	Auger Propelled
Stages	Single Stage
Chute Control	Manual
Warranty	3-Year Limited Warranty