ARIETE 4145 - Description of the Appliance; Appliance Components; Description of Attachments; Appliance Attachments Overview

IT
- 13 -
EN
DESCRIPTION OF THE APPLIANCE
Ref. Description Ref. Description
A
Steam dispenser button
G
ON/OFF light
B
Locking/unlocking cursor
H
ON/OFF switch
C
Gun
I
Boiler
D
Handle
L
Safety cap
E
Appliance body
F
Steam ready light
DESCRIPTION OF ATTACHMENTS
Ref. Description Ref. Description
①
Measuring cup
⑧
Window brush
②
Funnel
⑨
Extension tubes
③
Round brush
⑩
Fabric cloth
④
Small round brush
⑪
Fabric brush
⑤
Bent nozzle
⑫
Adapter with nozzle
⑥
Floor brush
⑬
Adapter for floor brush
⑦
Floor cloth
HOW TO OPERATE
Filling the boiler tank before use
Unscrew the safety cap (L) and, using the funnel (2) supplied, pour about two measuring cups (1) of water into the boiler •
(I) (Fig. 1).
Screw the safety cap (L).•
Mount the required attachment (see paragraph “ATTACHMENTS“) to the gun (C), inserting it until it locks and pressing •
the apposite upper locking/unlocking device on the gun (Fig. 2) at the same time.
Switching on
Plug the power cord into the socket and switch on the appliance using the On/Off switch (H), Fig. 3 . The ON/OFF light •
(G) and the steam ready light (F) will turn on.
After a few minutes, the steam ready light (F) will turn off, signalling that the boiler is pressurised and the appliance can •
dispense steam.
Operation
The steam ready light (F) turns off and on during use to signal the operating pressure has been reached.•
To avoid the accidental activation of steam, move the steam locking/unlocking cursor (B) from down to up (• ). To unlock,
move the cursor (B) from up to down ( ) (Fig. 4).
For dispensing steam, press the appropriate button (A) situated on the gun (C).•
When using the appliance for the first time, direct the steam jet into a container to remove any water residue in the pipe •
(any water leakage is caused by the steam condensation inside the pipe). Repeat the above operation also after few
minutes of standstill. Anyway, when the nozzle begins to supply steam, always direct the jet toward the floor.
ATTENTION: When the appliance is not used, always lock the steam push button (A) through the apposite
stop cursor (B).