20
GB
Cleaning the cup grill
7
and the water collection
container
8
:
Note: Empty the water collection container
8
peri-
odically
Remove the cup grill
7
and rinse it out under
running water
Remove the water collection container
8
, empty
it and rinse it out under running water
Cleaning the surface of the machine
CAUTION!
Only clean the permanent components of the machine
with a damp cloth to avoid damage to the casing
Descaling
Good maintenance and regular cleaning protect the
device, ensure a longer lifespan and limit the uild up
of limescale If the device still does not function
properly after some time ecause hard water and very
calcareous water have primarily een used, the lime-
scale must e removed to solve the prolem For this
purpose you should only use the Ariete descaling a
gent
NOAL with a citric acid ase
This product can e purchased easily at an Ariete cus-
tomer service centre Ariete accepts no liaility for dam-
age to components of the Espresso machine from the
use of non-compliant products with chemical additives
Follow the instructions on the instruction decalcifying
agent leaet
Shutting dow n
In case of shut down, you must detach the machine
from the power supply, empty the water tan and the
collection container and clean the device (see the
chapter leaning the device In case of scrapping,
you must tae care to dispose of the different individual
parts according to the applicale laws of the country
in which the device is eing used
Troubleshooting
Problem Cause Solution
Not releasing steam
Too little water in the water tan
18
the pump has no suction
hec whether the water tan
18
has een
inserted correctly and that there is enough
water in the water tan
18
Fill the water
tan
18
with fresh, still water up to the
A mar
The opening of the steam pipe
17
is
loced
Remove any lm which has uilt up at the
opening of the steam pipe
17
with a pin
Water ows out of
the side of the lter
holder
10
The lter
13
is proaly too full, mean-
ing the lter
13
cannot e properly
screwed into the frame
Remove the lter holder
10
very slowly, e-
cause this may lead to residual pressure and
a spraying of water lean the frame with a
small sponge Try it again with the correct
amount of coffee
There are its of ground coffee on the
seal of the coffee lter frame
Try it again with the correct amount of coffee
The hole in the silicone perforated
dis
12
is loced
Rinse out the silicone perforated dis
12
un-
der running water Turn it so that the middle
opening can e unloced y removing the
coffee powder that it stuc in it
1363_Espressomaschine_Content_IT_GB_FR_DE_ES_PT_NL_GR_RU_AE.indd 20 07.08.15 09:12
To Next Page
Loading...
