GB - 17
manual operation
Manual operation heats or cools the zone
in which the room sensor is installed, and
maintains the manual temperature set-
ting throughout the day (time scheduling
is disabled).
Press the "MODE" button until the display
shows “ ” (Fig. 4).
Modifying the room temperature
In manual mode, the set-point tempera-
ture (default value 20°C) can be modified.
Press the temperature adjustment keys
“
+” and “-” to set the room temperature
(Fig. 5). Press “OK” to confirm.
The set value will flash on the display for
a few seconds, after which the display
will once again show the detected room
temperature.
Disabling
heating/cooling
You can disable heating/cooling in the
zone in which the room sensor is in-
stalled.
Press the "MODE" button until the display
shows: “
”.
When heating is o, the anti-freeze func-
tion is enabled.
Anti-freeze function
When the anti-freeze function is enabled,
the display shows: “ ”.
In this mode, central heating will only ac-
tivate if the room temperature falls below
5°C, to protect the pipes against freezing
up.
Fig. 4
Fig. 5
Fig. 6
To Next Page
Loading...