INSTALLING THE ALTERNATIVE 40mm FASCIA PANEL:
Ariston 600 / 900 Slide-out Range Hood – ARHS 60X-L / ARH9SIX-L
This document is a quick
guide on how to replace the fascia panel (front rail) of your slide-out range hood.
This range hood model is factory fitted with an 80mm front rail that is suitable for both recirculating and ducted
installations. However, if the appliance is being installed in ducted mode, there is an option of replacing the
standard front rail with the 40mm fascia panel that is also supplied in the product packaging.
Disassembling the bracket that holds the sliding switches provides access to the screws that hold the front rail
in position. Please follow the instructions below when replacing the front rails.
2306013.001 – 80mm Fascia Panel (spare part)
2306013.002 – 40mm Fascia Panel (spare part)
2399000.414 – Sliding Switch (spare part)
Instructions
1 – Before installing the appliance, slide open the
filter drawer and remove both filter panels.
NOTE: remove the protective blue film from parts once the
installation is completed.
2 – Remove all 4 screws that hold the sliding switch
bracket in position. Two on each side of the filter
drawer (top and bottom).
To Next Page
Need help?
General
