EasyManua.ls Logo

Ariston ARWL 129 - Installation Procedures; Unpacking and Levelling the Machine

Ariston ARWL 129
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
NA
! This instruction manual should be kept in a safe place
forfuturereference.Ifthewasherissold,transferredor
moved, make sure that the instruction manual remains with
the machine so that the new owner is able to familiarise
himself/herselfwithitsoperationandfeatures.
!Readtheseinstructionscarefully:theycontainvitalinfor-
mation relating to the safe installation and operation of the
appliance.
Unpacking and levelling
Unpacking
1.Removethewasherfromitspackaging.
2.Makesurethatthewasherhasnotbeendamaged
duringthetransportationprocess.Ifithasbeendamaged,
contact the retailer and do not proceed any further with the
installationprocess.
3.Removethe4 protective
screws (used during tran-
sportation) and the rubber
washer with the correspon-
ding spacer, located on the
rear part of the appliance
(see figure).
4.Closeofftheholesusingtheplasticplugsprovided.
5.Keepallthepartsinasafeplace:youwillneedthem
againifthewasherneedstobemovedtoanotherlocation.
! Packaging materials should not be used as toys for
children.
Levelling
1.Installthewasheronaflatsturdyfloor,withoutrestingit
upagainstwalls,furniturecabinetsoranythingelse.
2.Ifthefloorisnotperfectly
level, compensate for any
unevenness by tightening
or loosening the adjusta-
ble front feet (see figure);
the angle of inclination,
measured in relation to the
worktop, must not exceed
2°.
Levelling the machine correctly will provide it with stability,
help to avoid vibrations and excessive noise and prevent it
fromshiftingwhileitisoperating.
Minimum Installation Spacing
This appliance may be installed in a recessed area, closet
oralcove.Theinstallationspacingisininchesandisthe
minimumacceptable.
*Additionalspacingshouldbeconsideredforeasyinstal-
lation, servicing and compliance with local codes and
ordinances.Installationsmustconformwiththeminimum
dimensionsindicated.
0" *
0" *
Recessed Front View
1" *
1"
Side View
Installation instructions

Table of Contents

Related product manuals