8
GB
The Receiver, connected to the boiler, re-
ceives the signal coming from the wireless
Timer-thermostat (transmitter) and con-
verts it into commands for the boiler.
Data is transmitted through radio waves,
therefore the transmitter (Timer-thermo-
stat) does not require any extra wiring.
This manual constitutes an integral and
essential part of the product.
Carefully read the instructions and
warnings contained in this manual: they
provide important information concern-
ing the operation and maintenance of
the device.
Installation, maintenance and any other
intervention must be performed by fully
qualifi ed personnel, in conformity to all
applicable regulations and the instruc-
tions provided by the manufacturer. In
the event of faults and/or malfunction,
switch the device off and do not attempt
to perform any repairs yourself. Contact
a qualifi ed professional instead.
Any repairs must be carried out by quali-
fi ed technicians using original spare
parts only. Failure to comply with the
above-mentioned recommendations
may jeopardise the device’s safety and
void the manufacturer’s liability.
CAUTION!
This device is not intended for use by per-
sons (including children) with reduced
physical, sensory or mental abilities, or
that lack the necessary experience and
knowledge, unless they are supervised or
have been adequately trained on the de-
vice's operation by a person responsible
for their safety.
Children must be supervised at all times
to ensure that they do not play with the de-
vice.
TECHNICAL DATA
Power supply mains 230V 50Hz
Protection rating IP30 (receiver and transmitter)
RF frequency fi eld 868 ... 868.6 MHz
Immunity to interruptions
Class 2 receiver
(ETSI EN300220-1 version 1.3.1)
Max. cable cross-sectional area 2.5 mm
2
To Next Page
Loading...
