USER’S MANUAL
/ 6
Initial operating procedures
Check the water pressure on the system pressure gauge and
make sure that the gure is between 0.6 and1.5 bar when the
system is cold.
The ignition of the burner is indicated on the display by the
symbol
the dashes underneath indicate the power
utilised.
THE ANTI-FROST FUNCTION REMAINS ACTIVE.
ATTENTION!!
SWITCH OFF THE BOILER COMPLETELY BY SWITCHING THE
EXTERNAL ELECTRICAL SWITCH TO THE OFF POSITION.
SHUT OFF THE GAS VALVE.
Switching off the heating
Switching off the boiler
To switch off the heating, press the ON/OFF button; the display
will switch off.
Ignition procedure
Press the ON/OFF button on the control panel to switch on the
boiler
The display shows :
Adjusting the heating
It is possible to set the temperature of the heating water by
pressing the buttons 8.
The temperature that may be obtained.which varies from 20°C
to 45°C (low temperature) and 35°C to 82°C (high temperature).
- the operating mode:
- the set temperature in central heating mode
ATTENTION!
DEAERATION CYCLE
THE DEAERATION CYCLE IS AUTOMATICALLY ACTIVATED
WHEN THE BOILER IS POWERED ON FOR THE FIRST
TIME. THE DISPLAY SHOWS “PURGEPURGE“.
AT THE END OF THE FUNCTION (7 MINUTES) THE
DISPLAY RETURNS TO NORMAL VIEW.
To Next Page
Loading...
Need help?
General