8
korisnički priručnik
user’s manual
- osigurajte da je pipac hladne vode otvoren
- osigurajte da je pipac plina otvoren
- uvjerite se da su baterije ( 1.5V LR20) pravilno
umetnute
- okrenite dugme između pozicija min i max
Uređaj je spreman za rad
Ot
varanjem slavine uređaj automatski počinje s radom.
Napomena: Ukoliko uređaj ne radi, provjerite jesu li
pipci za plin i /ili hladnu vodu otvoreni.
Osigurajte dotok električne energije.
Provjerite jesu li baterije umetnute.
Kada zatvarate slavinu, uređaj se automatski gasi.
Zamjena baterija
- otvorite poklopac spremnika baterija na dnu uređaja
- zamijenite baterije vodeći računa o polaritetima
označenima na uređaju.
PAŽNJA!
Korištene baterije ne mogu biti bačene u
okoliš.
Korištene baterije ne mogu biti ponovno
korištene.
Postupak paljenja plamenika
UPOZORENJE!
Voda temperature više od 50 C mož
e
izazvati ozbiljne opekline.
Uvijek provjerite temperaturu vode prije
korištenja.
Battery replacement
- unhook the battery compartment cover placed on
the bottom of the appliance
- remove the battery and replace observing the
polarities indicated on the device.
ATTENTION!!
Used batteries can not be dispersed in the
environment. Used batteries can not be utilized.
Ignition procedure
- ensure that the cock located on the cold water tting
is open
- ensure that the gas cock is open
- make sure the batteries provided (1.5V LR20) were
correctly inserted.
WARNING!!
Water with a temperature higher than 50°
cause serious burns.
Always verify water temperature before
use.
- Turn the knob between the positions of minimum
and maximum.
The device is ready to operate
By opening a tap, the device automatically starts
operating.
Note: If the device does not operate, ensure that the
gas and/or cold water cocks are open.
Ensure that the device is electrically powered.
Make sure the batteries were inserted.
When closing the tap, the device automatically switches
off.
To Next Page
Loading...
Need help?
General
