Ariston L 63 - Rack Rollers - Upper & Lower; Upper Spray Arm

REPAIR MANUAL
Page: 2
3. UPPER SPRAY ARM
• To remove the Upper Spray Arm (Fig. 3-1) gently grasp the Locking Ring with a Channel Locks and turn Counter-Clockwise
(Fig. 3-2); note the Tab and Slot locking configuration (Fig. 3-3).
TECH NOTE: When Replacing the Spray Arm make sure that it is tightened completely onto the Locking Ring.
Fig. 3-1 Fig. 3-2 Fig. 3-3
L 63 / LL 64 / LL 65
LI 640 / LI 670 / LI 700
2. RACK ROLLERS - Upper & Lower
• The Lower Rack Roller Assemblies are held in place using three (3) tension clips (Fig 2-4). Grasping the Roller Assembly and
applying downward force will disengage the Roller Assembly from the Rack.
Fig. 2-1
Fig. 2-2
Fig. 2-3
• The Upper Rack can be removed by releasing the Rail Clip and sliding the
Rack out from the Rail (Fig. 2-1). If the Upper Rack Roller Assembly must be
replaced (Fig 4-2) first remove the Side Panel (see Section 22) and then
remove the four (4) 8mm bolts that mount the Roller Assembly to the Tank.
• Once the Upper Rack has been removed, the Rack Roller Wheels can be
replaced by gently prying the Hub Clips inward with a small screwdriver and
then moving the Roller Wheel out and off the Hub (Fig. 2-3).
Fig. 4-4