19 / EN
DIAGNOSTICS
When a fault is detected, the appliance identifies three dierent types of errors:
• ERROR: all LEDs flash;
To reset an error, when possible, carry out the reset by pressing the ON/OFF key “
” to switch the
product o and on. If the cause of the fault disappears when reset, the appliance resumes its regular
operation. Otherwise, all the LEDs to flash again, Assistance must be requested to intervene.
• NOTICE: THE ON/OFF LED“
” flashes;
Carry out the reset by pressing the ON/OFF
“ ”
button to switch OFF the product, if the malfunction
persists, contact the Technical Assistance Centre
• TOUCH DISPLAY ERROR: all the temperature LEDs flash and the other LEDs are OFF;
Carry out the reset by cutting o the power supply to the product, if the malfunction persists, contact
the Technical Assistance Centre.
USEFUL INFORMATION
Before you clean the unit, make sure you have turned it o by setting its external switch to OFF. Do not use
insecticides, solvents or aggressive detergents: these can damage the unit’s painted and plastic parts.
If the water delivery is cold, have the following checked:
- that the device is connected to the power supply and the external switch is in the ON position;
- that at least led 40°C (Fig. 3) is turned on.
If there is presence of steam output from the taps:
Remove power from the electrical appliance and contact technical support.
If the hot water delivery is insucient, have the following checked:
- the pressure of the water mains;
- eventual obstruction of the inlet and outlet pipes (deformation or sediment).
Water trickling from the pressure safety device
During the heating phase, some water may trickle from the tap. This is normal. To prevent the water trickling, a
suitable expansion vessel must be installed on the flow system. If the trickling continues even after the heating
phase, have the following checked:
If the spill continues during the non-heating period, have the following checked:
- device calibration;
- the pressure of the water mains.
Caution: Never obstruct the appliance outlet!
IF THE PROBLEM PERSISTS, NEVER ATTEMPT TO REPAIR THE APPLIANCE YOURSELF, BUT ALWAYS
CONTACT QUALIFIED TECHNICIAN.
The indicated data and specifications are not binding; the manufacturer reserves the right to modify them
at his own discretion notification or replacement.
This product conforms to Directive WEEE 2012/19/EU.
The barred wheeled bin symbol appearing on the appliance or on its packaging indicates that the
product must be collected separately from other waste at the end of its useful life. The user must
therefore deliver the decommissioned product to an appropriate local facility for separate collection
of electrotechnical and electronic waste. Alternatively, the appliance to be scrapped can be delivered to the
dealer when purchasing a new equivalent appliance. Proper separated collection of the decommissioned ap
-
pliance for its subsequent recycling, treatment and eco-compatible disposal helps to prevent negative eects
on the environment and human health, besides encouraging reuse and/or recycling of its constituent materials.
To Next Page
Loading...
Need help?
General
