Green LED does not light up
Have you checked whether:
The main switch for the power supply to the apart-
ment or home has been turned off;
The plug is properly inserted in the outlet;
The outlet is adequate; try inserting the plug into an-
other outlet in the room.
The refrigerator and the freezer d o not cool properly.
Have you checked whether:
The doors do not close well or the se als are faulty;
The doors are left open too long;
The thermostat knob is not on the proper setting;
The refrigerator or freezer is overfilled.
The food in the refrigerator becomes too cold.
Have you checked whether:
The thermostat knob is on the proper setting;
The food is in contact with the back wall - which is
the coldest part.
The motor runs continuously.
Have you checked whether
The doors are not closed well or have remained
open too long;
The ambient temperature is too high;
The thermostat knob is not on the proper setting.
The appliance m akes too much noise.
The gas refrigerant produces a slight noise even when the
compressor is not running (this is not a defect).
Have you checked whether:
The refrigerator is levell.
The appliance was installed between cabinets or ob-
jects that vibrate and make noise.
There is water on the bottom of the refrigerator.
Have you checked whether:
The hole for draining the water from the frost is
clogged (see fig. 1).
If after all the checks, the appliance still does not operate
or the problem persists, call the nearest Service Centre
and inform them of: the type of problem, the abbreviation
of the model name (Mod.) and the relative numbers (S/N)
written on the rating plate located at the bottom le ft next
to the vegetable crisper (see examples in the figures be-
low).
Never call on unauthorized technicians and always re-
fuse spare parts, which are not originals.
- As a result of thermal strain for components of a
refrigerator appliance can be heard crackling noise
that is not a defect and doesn’t affect efficiency of
the appliance. This special sound when the
thermoregulator and compressor are turned on is a
normal state, which appears during the working
process of the appliance’s electric installation.
- After some time the color of indicator lamp can be
changed and color depth can be decreased, it
should be considered as natural process and you
shouldn’t worry about it.
- Replacing the lamp. The lamp for lighting the
interior of the appliance is located at the back of the
lamp box. Unscrew the burnt lamp and replace it
with another lamp of no more than 15 Watt, follow
the instructions illustrated in fig. 3
Fig. 3
1
1
2
To Next Page
Loading...
