Aritech DP721R - User Manual

© 2021 Carrier. All rights reserved. 1 / 28 P/N 10-4226-501-1C70-09 • ISS 08JUN21
700 Series Conventional Point Detector
Installation Sheet
EN CS DA DE ES FI FR HU IT NL NO PL PT RO SV TR
1
2
3
4
EN: Installation Sheet
Description
The 700 Series Conventional Point Detectors are compatible
with with DB702 and DB702U mounting bases.
Table 1: 700 Series Conventional Point Detectors
Model
Detector type
DP721I
Optical Smoke Detector with Remote Indicator Output
DP721R
Optical Smoke Detector with Relay Output
DP721RT
Optical/Heat Multi Detector with Relay Output
DP721T
Optical/Heat Multi Detector with Remote Indicator Output
DT713
-5 Heat Detector, 57° C fixed and rate of rise heat detector
DT713
-5R
Heat Detector, 57° C fixed and rate of rise heat detector
with relay output
DT713
-7 Heat Detector, 70°C fixed and rate of rise heat detector
Installation
Caution: For general guidelines on system planning, design,
installation, commissioning, use and maintenance, refer to
CEN/TS 54-14 and to local regulations.
To install a detector:
1. Insert the detector head into the mounting base and rotate
it clockwise until it clicks into place.
The detector may be locked into the mounting base if required.
To do this remove the locking tab on the detector before
installation (Figure 1).
Every 700 Series base features a continuity link between LINE
IN (1) and LINE OUT (2) terminals of the conventional detector
circuit. The base is supplied with the link in closed position.
The link is enabled by default allowing you to check the zone
wiring using only the bases. The link will automatically
disconnect when a detector is inserted, allowing the panel to
generate a fault message when the detector is removed.

Summary

Installation Sheet

Description

Summary of the 700 Series Conventional Point Detectors and their compatibility with mounting bases.

Installation

General guidelines and steps for installing the detector, including cautions and base continuity.

Maintenance

To remove a locked detector

Instructions for removing a detector that has been locked into its mounting base.

To replace the optical chamber

Procedure for replacing the optical chamber of the detector.

Testing

Procedure for in-depth sensitivity testing using the integral reed switch.

Specifications

Regulatory information

Aritech DP721R Specifications

General

Brand	Aritech
Model	DP721R
Category	Security Sensors
Language	English