Step 3. Battery confirmation - CALCIUM batteries only
If you selected CALCIUM battery you will be asked to confirm your selection. Calcium batteries need to
be charged at a much higher voltage which could cause damage to other battery types.
- Select YES if you are charging a CALCIUM battery – Proceed to step 4
- Select NO return to Battery type selection
Step 4. Battery Capacity Selection
Using the MENU buttons, scroll up or down to your battery size in Ah (amp hours) rating and press OK
to select. If your battery Ah rating is not listed then select the next level down i.e battery size 105Ah –
select 100Ah
Your battery setup is now complete and the main data page will appear. The charge process for your
specific battery chemistry will commence in 30 seconds.
These settings are now saved in the ArkPak. Please note the next time you turn the ArkPak on the
welcome screen is bypassed and the main data screen will appear.
If you disconnect the saved battery or connect a new battery the welcome screen will appear first (refer
to step 1) and you’ll need to select ‘yes’ or ‘no’ again.
6
CAUTION – the ArkPak only saves the last battery setup, the setup process will have to be
completed every time a different battery is charged
To Next Page
Loading...