5
CARE AND CLEANING
The heater requires regular cleaning to ensure trouble free operation:
Unplug the heater from mains supply before cleaning.
Use a rung out (damp) cloth to wipe the exterior of the heater to remove dust and
dirt.
Use a vacuum cleaner to remove dust and debris from the inlet and outlet grills.
To clean behind the heater when mounted on the wall, unfasten the 2 locking screws
located on the top of the mounting bracket, press down on the 2 release catches on
the mounting bracket to tilt the heater forward. When the heater is tilted forward, it is
easier to clean behind it.
Otherwise the unit can be lifted clear of the bottom hooks. It is important to return the
heater to its original position after cleaning and to tighten the locking screws.
Ensure heater is dry before plugging back into the mains supply.
OVERHEAT PROTECTION
This product has protective safeguards that shut off the product when parts become
in danger of overheating. If it does overheat, switch off your appliance and remove
the mains plug from the power socket. Allow your appliance to cool for at least 30
minutes. The appliance will function again when it has cooled down. Carefully check
for any obvious causes such as curtain or clothes that may have prevented air from
circulating through the appliance.
PROGRAMMING
Introduction
Your programmable Arlec panel heater will provide controlled background warmth
when you require it so as to minimize electricity usage. The heater is equipped with
an electronic thermostat and a 24 hour/7 day timer with 2 timer periods that control
the temperature within a set program.
• Comfort Period – refers to the time period when you want the heater to heat your
room to your desired temperature when you are present. The default temperature
setting for the “Comfort Period” is 22°C.
• Economy Period – refers to the time period when you are not present but would
like a minimal amount of heating so the room does not become completely cold.
The default temperature setting for the “Economy Period” is 17°C.
To switch the Economy Period heating off so that no energy is used between your
selected Comfort Periods it is necessary to change the Economy Period tempera-
ture setting to 5°C. Refer to Adjusting Program Settings.
For your convenience this heater is equipped with 12 pre set programs and one User
Program (UP).
IMPORTANT NOTE:
If the ON/OFF switch or Mains Power switch is turned off your personal settings or User
program (UP) will be retained, however, the clock will need to be reset to the correct
time.
PEH002 Instructions.indd 5 22/12/09 2:30:11 PM
To Next Page
Loading...
Need help?
General
