9
SETTING THE USER PROGRAM (UP)
END STEPS (Refer to Fig.3) DIGITAL DISPLAY (Refer to
Fig.4)
SETTING THE USER
PROGRAM (UP) FOR THE
WEEK
Press Program Selection ‘p’
button “5”.
The display will show the
day, the Pre Set Program,
temperature and program
sequence.
Use the UP and DOWN
buttons to select the
program “UP”.
The program “UP will flash.
Press the programming
button “PROG” “6”
Press program selection ‘p’
button “5”
The program “UP” will stop
flashing.
To set the UP program to
start on a specific day:
Press the TIMER button “8”
repeatedly until the correct
day is selected.
The Selected “day” will be
shown.
PROGRAMMING THE
ECONOMY AND COMFORT
PERIODS
Use either the DOWN
button “10” to enter
the required Economy
periods or the UP button
“11” to enter the required
Comfort periods. The
timer Advances in 30min
intervals.
The Comfort period units
displayed in the program
will be replaced by
Economy period units when
the DOWN button “10” is
released, the next Comfort
period unit will flash.
PROGRAMMING A 24
HOUR DAY
Complete the
programming for the
whole 24 hour day with
Economy and Comfort
Periods.
Press timer button to
proceed to next day.
After programming the
full 24 hours, the timer will
display 00:00 (midnight).
The unit is now ready for
programming the next
24 hour day. You must
complete a 24 hour profile
before it will take effect.
COPYING THE 24 HOUR
PROFILE
If the same 24 hour profile
applies for several days in
the week. Press the TIMER
button “8” to select the day
to be copied.
-Press the COPY button “9”.
-Press the TIMER button “8”
to the desired day.
-Press the COPY button “9”
to complete.
“COPY” will be shown and
the “day” will flash.
This will display the day
that you wish to copy the
program. The “day” will
flash.
The word “COPY” will
disappear and the “day”
will stop flashing.
ENDING THE PROGRAMING Press the “PROG” button. Will show the current
program.
PEH002 Instructions.indd 9 22/12/09 2:30:12 PM
To Next Page
Loading...
Need help?
General
