88
mechanical damage and microscopic cracks in the seal,
water can penetrate into the smartwatch and cause
damage.
5. You have stopped receiving incoming calls or SMS
notifications – check that the smartwatch is paired with
your phone and the notifications are allowed in the app
(Fig. 3) and in the settings of your phone, and that the
do-not-disturb mode has not been activated in the app.
Make sure Bluetooth is on in your phone. Do not pair the
smartwatch via the phone’s Bluetooth menu.
6. The smartwatch cannot be paired with a phone – possible
solutions:
- make sure the smartwatch and phone are charged
sufficiently
- make sure your phone’s Bluetooth and GPS are
switched on and you have allowed your location/
position to be tracked in your phone’s settings
- place the smartwatch and the phone next to each other
- check the system updates in your phone
- uninstall and re-install the app
- restart your phone and switch the smartwatch
off then back on again
- make sure your phone meets the technical requirements
(Android 5.1+, iOS 9.0+, Bluetooth 5.0+)
7. The green sensor light is blinking – data measurement or
transfer is underway.
8. The green sensor light blinks even when the smartwatch is
not being worn – it is not a flaw.
9. To ensure the correct functioning of the smartwatch,
we recommend restarting or resetting the smartwatch
occasionally and, where a newer version is available,
updating firmware in the app. Make sure you always have
the most recent version of the app.
10. Always charge the smartwatch for no more than 2 hours
(at no more than 5 V). Improper charging reduces the
capacity and useful life of the battery. Battery life depends
on the ambient temperature and the number of functions
EN
To Next Page
Loading...
