ArmorAll DVTB202 0901 - Liquid Vacuum Operation; Blower Operation

9
IMPORTANT!
When vacuuming large quantities of liquids, do not immerse the
nozzle completely in the liquid; leave a gap at the tip of the nozzle opening to allow
air inow. The machine is tted with a oat valve that stops the suction action when
the collection tank reaches its maximum capacity. You will notice an increase in motor
speed. When this happens, turn off the machine, disconnect from power supply, and
drain the liquid into a suitable receptacle or drain. To continue vacuuming, ret the
power head to the collection tank. After wet vacuuming, turn the machine off and remove
the battery. Empty the collection tank, clean and dry the inside and outside before
storage.
Note: The provided lter can be used for both wet and dry vacuum operation.
1. Verify that the cartridge lter is securely mounted. ( Fig. 5) For installation instructions see page 12.
2. Insert the hose into the vacuum port. (Fig. 6)
3. Push required accessories onto the free end of the hose. (Fig. 7)
4. Make sure the battery pack is correctly installed. (Fig. 8) For installation instructions see page 7.
5. Turn the motor on by ipping the switch to the 'I' ON position. (Fig. 9)
6. Once you have completed vacuuming, or when the tank is full, turn the motor off by ipping the
switch to the 'O' OFF position. (Fig. 10)
7. Remove the battery. (Fig. 11)
8. Empty the collection tank into a suitable receptacle or drain. (Fig. 12)
This wet/dry vacuum has blowing capabilities. To use the blower feature follow the
instructions listed.
WARNING:
ALWAYS WEAR SAFETY GOGGLES WHILE USING BLOWER.
WARNING:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
INHALED.
BLOWER OPERATION
LIQUID VACUUM OPERATION