ArmorAll VBV809 0901 - Installing & Cleaning Foam Sleeve Filter; Troubleshooting

11
INSTALLING & CLEANING FOAM SLEEVE FILTER
43 5
2
o
Installing Foam Sleeve Filter
1. Verify that the power cord is disconnected from the outlet. (g. 1)
2. Remove power head and place in upside down position. Follow instructions to remove cartridge lter.
3. Carefully slide foam sleeve lter down over the lter cage making sure the whole cage is covered. (g. 2 & 3)
4. Replace the power head on to the container.
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam sleeve lter. (g. 4)
2. Use a mild soap and water solution to wash foam sleeve lter and rinse with clean water. (g. 5)
3. Allow lter to air dry before installing and using again.
Symptom Possible Causes Corrective Action
Vacuum will not operate 1) No power supply.
1) Check power supply – cord, breakers,
fuses.
2) Faulty power cord.
2) Unplug and check the power cord. If
damaged, have it repaired by a professional.
3) Container full. 3) Empty container.
Dust comes from motor cover.
1) The cartridge lter is missing or
damaged.
1) Attach or replace the cartridge lter.
Reduced efciency and motor/
speed vibration.
1) There is a blockage in the nozzle,
hose, or the vacuum inlets. Or the dust
lter is blocked by ne dust.
1) Check nozzle, hose and container inlets
for blockage. Take off the lter and clean it.
Or install new lter.
TROUBLESHOOTING
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK-UNPLUG BEFORE TROUBLESHOOTING