Need help?Do you have a question about the Armstrong 4030 Series and is the answer not in the manual?
General| Power Source | Electric |
|---|---|
| Shaft Seal | Mechanical Seal |
| Material | Cast Iron, Stainless Steel |
| Operating Temperature | Up to 250°F |
| Inlet Size | 2" - 4" |
| Applications | Industrial |
| Outlet Size | 2" - 4" |
Essential safety rules for installation and operation.
Explains safety icons used in the manual.
Specifies safe operating temperature ranges.
Procedures for storing, unpacking, and handling the pump.
Proper placement of the pump for service and operation.
Steps to ensure the pump and motor shafts are level.
Process to achieve and verify shaft alignment.
Instructions for filling the baseplate with grout.
Guidance on suction and discharge piping configuration.
Verifying alignment after piping connection.
Procedures for safely starting the pump.
Information on sealed bearings that require no external lubrication.
Instructions for oiling bearings, including oil type and level checks.
Guidance on motor lubrication, referencing manufacturer recommendations.
Lists common reasons why a pump might not deliver fluid.
Identifies potential causes for pump vibration.
Outlines common issues leading to seal leaks or failures.
Details reasons for reduced fluid delivery from the pump.
Lists causes for the pump not generating adequate pressure.
Explains factors contributing to premature bearing wear.
Common causes for bearing overheating in the pump.
Identifies reasons for stuffing box overheating.
Lists issues causing pump delivery failure shortly after startup.
Explains potential causes for the pump becoming seized.
Details reasons why the pump might fail to prime.
Outlines common causes for pump noise.
Lists factors leading to motor overloading.
To Next Page