FAB I
ntelligent
C
ontroller
IMPORTANT APPLICATION NOTES:
1. The AF-C232/D232, AF-C485/D485, and LCD board, when a FAB is
powered, must not be plugged in or out.
2. The default password for FAB is 0001.
3. The default address for FAB is 000.
4. When programming, the output of two function blocks must not be
connected to one point, except for the CW function block.
For example:
The above way is wrong, and the correct way is as follows:
Safety Guide
This manual contains the precautions necessary for ensuring your personal
safety as well as for protection of the products and the connected equipment. These
precautions are highlighted with a triangle WARNING symbol in this manual and
are marked according to the danger levels as follows:
Danger
It indicates that if appropriate precautions are not taken, serious incidents of
personal injury or death, signicant damages and loss of properties will be caused.
Caution
11
12
13
&
M1
Q1
>1
&
11
12
13
&
&
M1
>1
M2
Q1
To Next Page
Loading...
Need help?
General
