Array electronic AF-10MR-A User Manual

C
hapter
Ⅳ
P
rogramming on
FAB
panel
3. Input the password (assume the password is 2165);
Press
twice and the rst digit value of the password will change to 2;
Press right moving key
and the cursor will move to for the second digit of
the password value to be input;
Press
once and the second digit of the password value will become 1;
Press
again and the cursor will move to the third digit of the password value
to be input
Press
6 times and the third digit of the password value will become 6;
Press
and the cursor will move to the last digit of the password value to be
input;
Press
5 times and the last digit of the password value will become 5.
After the password is completely input, the following will be displayed on the
LCD panel:
Fig. 4.27
4. Press to enter the Editing Function Selection Frame with the selection
mark > staying at Editor Function then the following is displayed on the LCD
panel:
Fig. 4.28
Step 2: Edit Function Diagram
1. Press
to select Editor. After the display of Edit Prg, press OK to enter
the Function Block Selection List which is displayed on the LCD panel as fol-
lows:
Verify
Users
Password;
2165
57
>Editor
FAB/Rom
Set..
RUN

Array electronic AF-10MR-A Specifications

General

Brand	Array electronic
Model	AF-10MR-A
Category	Controller
Language	English