5. How to Adjust the Parameters
For adjusting the parameters, you can check the Simple BGC user manual. Or you
can also download it from http://www.basecamelectronics.com/downloads/32bit/
Since we have adjusted all the settings when we send the gimbal out, please do not
change those settings casually.
6. How to load the stock settings
If you click the “Use Default” or changed some settings, the gimbal could not work
propeller, you can load the stock settings into the gimbal. The following is the
procedure:
6.1 Connect the gimbal to the software, and choose the right port, and click
“connect”;
6.2 Load the stock settings to Profile 1, and then click “Write” to save it;
6.3 Click Profile 2, load the stock settings, and then click “Write” to save it;
6.4 Remain the Gimbal still and make sure it is horizontal, next please click
“Camera IMU”, and then “CALIB.ACC” to calibrate the sensor. Next, click
“Frame IMU”, and then the “CALIB.ACC” to calibrate the other sensor. Wait a
few seconds, it will be OK.
6.5 Return to Profile 1, and click the “Follow Mode”, and choose “Follow Yaw”,
then click “Write to save it”
6.6 Disconnect it.
6.7
(The stock setting comes with the gimbal on the CD. If you could not find it, you
can contact the producer)
To Previous Page
Loading...