Arrma 4x4 BLX - Radio Gear Setup and Binding; Factory Defaults and Binding Process; End Point Adjustment Guide

© 2018 ARRMA RC. A trade name of Horizon Hobby Ltd
Factory Defaults
Steering CH1/Throttle CH2 channels see table. Steering and Throttle trim set to middle/zero
adjustment. Steering Dual Rate at 100% fully clockwise.
Remove receiver
box lid
Binding
Press and hold
bind button
Switch on Car
LED stops blinkingReceiver LED will
blink
Switch on
transmitter
CH1-
ST
NOR REV
CH2-
TH
NOR REV
Apply throttle or
brake
Place vehicle o󰀨 the
ground and switch
on
Throttle End Points
Turn steer-wheel left or
right
Grip buttons move end
point
Steering End Points
The grip buttons
adjust the end points
End Point Adjustment
Turn steer-wheel fully
right
Apply full throttle
(pull)
Power on Transmitter Power LED will ash
ve times
To enter programming
mode:
Always Turn o󰀨 car rst and then transmitter to save settings
14