How to fix Arrma Toy that drives without input?
If your Arrma Toy is driving without any input, it could be due to: * The Arrma ATX transmitter throttle trim being incorrectly set. The throttle trim needs to be set to zero/neutral. * An incorrect neutral throttle position of the MEGA ESC. Set the throttle trim to zero and switch the MEGA ESC off and then on again. A chime will indicate the new neutral position has been set.
Why does my Arrma RAIDER Motorized Toy Car have a short runtime?
Short runtime in your Arrma Motorized Toy Car can be caused by a damaged or not fully charged battery; check the battery's condition and replace or recharge it as needed. Another cause might be a dirty or damaged MEGA Electric motor; clean, check its condition, and replace if necessary. Finally, the ESC battery mode could be incorrect, with the voltage cutoff set too high for your battery; adjust the battery mode of the MEGA waterproof ESC.
How to fix sluggish performance of Arrma RAIDER?
Sluggish performance in your Arrma Motorized Toy Car can stem from several factors. Begin by checking the battery; it may be damaged or not fully charged, so replace or recharge it as necessary. Ensure the ARRMA ATX transmitter throttle trim is correctly set to zero/neutral. Also, verify the neutral throttle position of the MEGA ESC is correct by setting the throttle trim to zero and switching the MEGA ESC off and then on again. A loose slipper clutch adjustment can also cause this; check if the slipper is set to the factory or your preferred setting. Adjust the MEGA waterproof ESC settings if the initial acceleration mode or reverse speed is set too low. A dirty or damaged MEGA electric motor or drivetrain can also lead to sluggishness; clean, check, and replace components as needed.
How to increase steering angle on Arrma RAIDER Motorized Toy Car?
A limited steering angle on your Arrma Motorized Toy Car can be caused by a few things. First, check the ARRMA ATX transmitter steering dual-rate setting; adjust the ARRMA ATX transmitter dual-rate. Also, inspect for any damaged steering components and replace them if necessary. Lastly, a damaged MEGA waterproof ESC could be the culprit, and you may need to replace it.
What to do if I have no control of Arrma Motorized Toy Car or short range?
If you're experiencing a lack of control or short range with your Arrma Motorized Toy Car, first check the transmitter batteries to ensure they are not weak or incorrectly installed. Next, verify that the servo and ESC signal wires are securely and correctly connected to the ARX receiver. Lastly, ensure that the transmitter and receiver are properly 'bound'. If not, they will need to be bound correctly.
Why does Arrma Toy vehicle wander left or right without steering input?
If your Arrma Toy vehicle wanders left or right without steering input: * The Arrma ATX Steering trim setting might be out. Adjust the steering trim. * There may be damaged steering components. Check components and replace them. * The drivetrain might be dirty or damaged. Clean, check its condition and/or replace it.
What causes limited steering angle in Arrma Toy?
A limited steering angle in your Arrma Toy can be due to: * The Arrma ATX transmitter steering dual-rate being set incorrectly. Adjust the Arrma ATX transmitter dual-rate. * Damaged steering components. Check components and replace them. * A damaged MEGA waterproof ESC. Replace it with a new unit.
How to stop Arrma Toy front wheels lifting when accelerating?
If the front wheels of your Arrma Toy lift when accelerating, it's likely that the slipper clutch adjustment is too tight. Check if the slipper is set to the factory setting.
What to do if Arrma Toy has no control or short range?
If you're experiencing a lack of control or short range with your Arrma Toy, check these: * The Arrma ATX transmitter batteries might be weak or incorrectly fitted. Ensure they are correctly installed. * The servo and ESC signal wires to the ARX receiver might be loose or incorrectly connected. Reinstall the signal wires to the receiver. * The Arrma transmitter and receiver might not be 'bound' correctly. They need to be bound.
How to correct reversed steering or throttle on Arrma Motorized Toy Car?
If the steering or throttle function is reversed on your Arrma Motorized Toy Car, the relevant channel of the ARRMA ATX transmitter might be reversed; reverse the relevant channel on the ARRMA ATX transmitter. Also, check that the wires from the ESC to the motor are connected correctly; reconnect them in the correct orientation (orange to red and blue to black), ensuring a tight fit.
General safety guidelines and warnings for operating the high-performance RC model.
Explains the ARRMA ATX 2.4Ghz transmitter and ARX300 receiver controls and features.
Covers battery safety instructions and low-voltage/idle alarms for the transmitter.
Information on the MEGA waterproof ESC, its LED status, and protection features.
Step-by-step guide to adjust ESC settings like acceleration and battery mode.
Provides basic tips and techniques for driving the RC car, including cornering and handling.
A matrix of common problems, their possible causes, and suggested solutions for the RC model.
General| Scale | 1/10 |
|---|---|
| Motor Type | Brushed |
| Vehicle Type | Buggy |
| Battery Type | NiMH |
| Chassis Material | Composite |
To Next Page
