32
Assemblies from Step 3:
• Main Roof Beam Assembly (1)
• Single Roof Beam Assemblies (2)
(QTY: 12)
CUT
Tape BOTH Gable joints before installing Roof Beams.
You will need for this page:
Weather Stripping Tape
Top View of Gables
Tape should wrap around gap between Gables.
Step 12: Roof Framing
Beam End Views
Angled side of Beams must face up.
Seal the gap between the Gables
using the weather stripping tape as
shown. Do this at both ends of the
building before installing Roof Beams.
Position the Roof Beams as shown
below and install using two (2) bolts
and nuts per side. Install the Main
(center) Beam fi rst.
32A
To Next Page
Loading...
