Art SGX-2000 - Sampler-S; Sampler-L; Sampler+Ptr

33
:HFDAMP= 0 to 100 percent in % increments [0%]
:LEVEL= 0 to 100 percent in % increments [100%]
*Total possible delay is 1350ms
You can split image or create alternating regenerative patterns between the left
and right outputs using Stereo Digital Delay. The ability to set separate delay
times for each channel enables you to do this. When used in conjunction with the
Flanger, Chorus or Panner, spatial effects are the result. Regeneration is
derived from the left channel.
When longer delay times are needed, use the STREO-DDL-L algorithm. Set both Left
and Right Delay times at 1300 ms for maximum delay output with no separation. You
may also operate this effect in mono.
SAMPLER-S
[SAMPLER-S], [SMP]
Sampler-Short
Parameters:
STAT=REC-RDY, PLAY, IDLE [REC-RDY]
RECORD=AUTO, MANUL, MIDI [AUTO]
PLAY=SINGLE, PUNCHIN, MIDI, REPEAT, AUDIO [SINGLE]
LENGTH= 0.02 to 1.30 seconds in 20ms increments [1.3s]
START= 0 to 100ms in 1ms increments [5ms]
LEVEL=0 to 100 percent in % increments [100%]
SAMPLER-L
[SAMPLER-L], SMP
Sampler-Long
Parameters:
STAT=REC-RDY, PLAY, IDLE [REC-RDY]
RECORD=AUTO, MANUL, MIDI [AUTO]
PLAY=SINGLE, PUNCHIN, MIDI, REPEAT, AUDIO [SINGLE]
LENGTH= 0.02 to 1.58 seconds in 20ms increments [1.58s]
START= 0 to 100ms [5ms]
LEVEL=0 to 100 percent in % increments [100%]
SAMPLER+PTr
[SAMPLER+PTR], [SPT]
Sampler Plus Pitch Transposer
Parameters:
STAT=REC-RDY, PLAY, IDLE [REC-RDY]
RECORD=AUTO, MANUL, MIDI [AUTO]
PLAY=SINGLE, PUNCHIN, MIDI, REPEAT, AUDIO [SINGLE]
LENGTH= 0.02s to 1.25 in 20 ms increments [1.25s]
START= 0 to 100ms [5ms]
PITCH= (-)12 to (+)12 half steps in 1 half step increments [0]