Artopex e-Motion - Upward Obstacle Sensitivity (4 Fu); Downward Obstacle Sensitivity (5 Fd)

1 800 378-0189
sac@artopex.com
7
Settings (cont’d)
Upward Obstacle Sensitivity - 4Fu
The upward sensor allows the surface to detect resistance (obstacles) as it moves upward.
Activate keypad by pressing any button. Press «M» button for 3 seconds, screen will display S--, then
release the «M» button and press the «up» arrow until code 4Fu appears. Press «M» button to enter.
Default setting is L3, which is just under mid-level sensitivity. Use the UP/DOWN buttons to toggle
between levels L1 (most sensitive) to L9 (least sensitive), L0 deactivates the sensor (not recommended).
Press the «M» button to confirm selection.
Downward Obstacle Sensitivity - 5Fd
The downward sensor allows the surface to detect resistance (obstacles) as it moves downward.
Activate keypad by pressing any button. Press «M» button for 3 seconds, screen will display S--, then
release the «M» button and press the «up» arrow until code 5Fd appears. Press «M» button to enter.
Default setting is L3, which is just under mid-level sensitivity. Using the UP/DOWN buttons to toggle
between levels L1 (most sensitive) to L9 (least sensitive), L0 deactivates the sensor (not recommended).
Press the «M» button to confirm selection.
Vibration Sensitivity - 6FS
The vibration sensor causes the table to stop moving if it detects, for example, that someone bumped it up
during its travel or that there is a large weight o-center on the surface.
Activate keypad by pressing any button. Press «M» button for 3 seconds, screen will display S--, then
release the «M» button and press the «up» arrow until code 6FS appears. Press «M» button to enter.
Default setting is L5, which represents mid-level sensitivity. Use the UP/DOWN buttons to toggle
between levels L1 (most sensitive) to L9 (least sensitive) and press the «M» button to confirm selection.